Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual

▶
"Switching on the server" on page 58
.
When the system is powered on after a CPU has been replaced or
upgraded, the Global Error indicator will start flashing with the message
CPU has been changed.
This only indicates that the CPU configuration has been altered. There
is no technical problem.
Proceed as follows:
●
Restart your server.
●
As soon as the startup screen appears, press the
[F2] function key to
enter the BIOS.
●
If a password is assigned, enter the password and press [Enter].
●
Select the Save & Exit menu.
●
Select Save Changes and Exit or Save Changes and Reset.
●
Verify that the Global Error indicator stops flashing.
▶
"Resetting the error status after replacing memory modules or CPU" on
page
76
.
▶
"Enabling replaced components in the BIOS" on page 81.
▶
"Resuming BitLocker functionality" on page 86.
11.4 Replacing the heat sink
Field Replaceable Unit
(FRU)
Hardware: 15 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
Depending on ATD support, there are different heat sinks available, see
" Types of heat sinks (A)" on page 242
and "Types of heat sinks (B)" on
page 243.
Processor (CPU)
RX1330 M4 Upgrade and Maintenance Manual 253

Fujitsu PRIMERGY RX1330 M4 Specifications

General

Chipset	Intel C246
Processor	Intel Pentium, Intel Celeron
Memory Type	DDR4
Memory	Up to 64 GB
Memory Slots	4 DIMM slots
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
Network	2x 1GbE onboard, optional additional NICs
Power Supply	450W
Form Factor	1U
RAID Controller	optional SAS RAID controller