Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual

▶
Remove the serial interface.
Installing the slot cover
▶
Install the corresponding slot cover
, see "Installing the slot cover" on
page
204.
▶
Install the corresponding riser module, see "Installing a riser module" on
page 61.
Concluding steps
▶
"Reassembling" on page 52.
▶
"Connecting the power cord" on page 56.
▶
"Switching on the server" on page 58.
▶
"Resuming BitLocker functionality" on page 86.
14.4 Replacing the serial interface
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: tool-less
Preliminary steps
▶
"Suspending BitLocker functionality" on page 65
.
▶
"Shutting down the server" on page 45.
▶
"Disconnecting the power cord" on page 46.
▶
"Getting access to the component" on page 48.
Removing the defective serial interface
▶
Remove the serial interface, see "Removing the serial interface" on
page 286.
Serial interface
288 Upgrade and Maintenance Manual RX1330 M4

Fujitsu PRIMERGY RX1330 M4 Specifications

General

Chipset	Intel C246
Processor	Intel Pentium, Intel Celeron
Memory Type	DDR4
Memory	Up to 64 GB
Memory Slots	4 DIMM slots
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
Network	2x 1GbE onboard, optional additional NICs
Power Supply	450W
Form Factor	1U
RAID Controller	optional SAS RAID controller