Concluding steps
▶
If applicable, install riser modules 2 and 3, see "Installing a riser module" on
page 61
.
▶
"Reassembling" on page 52.
▶
"Connecting the power cord" on page 56.
▶
"Switching on the server" on page 58.
15.6.3 Replacing an M.2 SSD
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Software: 15 minutes
Tools: Phillips PH1 / (+) No. 1 screw driver
Preliminary steps
▶
"Locating the defective server" on page 43
.
▶
"Shutting down the server" on page 45.
▶
"Disconnecting the power cord" on page 46.
▶
"Getting access to the component" on page 48.
▶
If applicable, remove the riser modules 2 and 3, see "Removing a riser
module" on page 59.
Replacing the M.2 SSD
▶
Remove the defective M.2 SSD, see "Removing the M.2 SSD" on page 315.
▶
Install the new M.2 SSD, see "Installing the M.2 SSD" on page 311.
Concluding steps
▶
If applicable, install riser modules 2 and 3, see "Installing a riser module" on
page 61.
▶
"Reassembling" on page 52.
System board and components
316 Upgrade and Maintenance Manual RX1330 M4
To Next Page
Loading...
