RX900 S1 Maintenance Manual 183
Main memory
9.1 Installing a CPUMEMR
I The CPUMEMRs must be installed according to the configuration rules
summarized in "Selecting the CPUMEMR slot" on page 184 and
described in the "Baseboard D3081, CPUMEMR D3131, PCIR D3082
for PRIMERGY RX900 S1 Technical Manual".
9.1.1 Required tools
● Starting and completing the task:
– key for the rack doors (if applicable)
– Phillips Ph2 screw driver
● Installing the CPUMEMR: tool-less
9.1.2 Starting the task
Ê Perform the following procedures:
1. "Opening the rack door" on page 40
2. "Shutting down the server" on page 41
3. "Sliding the server out of the rack" on page 42
4. "Opening the server" on page 44
Authorized personnel
Authorized specialist personnel can carry out replacement tasks for
integral server components. Ask you local Fujitsu service center for
more detailed information.
V CAUTION!
Procedures indicated as "Authorized personnel only“ must be
done by Fujitsu service personnel or technicians trained by
Fujitsu for doing these tasks. Please note that unauthorized
interference with the system will void the warranty and exempt the
manufacturer from all liability.
To Next Page
Loading...
