Fujitsu PRIMERGY RX900 S1 - Removing the TPM; Starting the Task

274 Maintenance Manual RX900 S1
Baseboard
14.5.2 Starting the task
Ê Perform the following procedures:
1. "Opening the rack door" on page 40
2. "Shutting down the server" on page 41
3. "Sliding the server out of the rack" on page 42
4. "Opening the server" on page 44
14.5.3 Removing the TPM
Figure 171: Removing the TPM board
Ê Remove the TPM screw.
Ê Disconnect and remove the defective TPM board.
I The TPM spacer remains on the baseboard.