Fujitsu PRIMERGY RX900 S1 - Installing the Rear Cover

48 Maintenance Manual RX900 S1
Basic procedures
Ê Place the front cover onto the server such that there is approximately 1 cm
distance to the front.
Ê Push the front cover as far as possible in the direction of the arrow.
Ê Fasten the captive screw on the cover (see circle).
4.6.2 Installing the rear cover
Figure 9: Installing the rear cover
Ê Place the rear cover onto the server such that it projects approximately 1 cm
at the back.
Ê Push the rear cover as far as possible in the direction of the arrow.
Ê Fasten the captive screws on the cover (see circles).
/
0