Tools: Phillips PH2 / (+) No. 2 screw driver
The CPU fan is implemented in the heat sink. When the CPU fan is
defective, the heat sink must be replaced.
Preliminary steps
▶
"Unlocking the server" on page 39
.
▶
"Removing the bay cover" on page 40.
▶
"Shutting down the server" on page 41.
▶
"Disconnecting the power cord" on page 42.
▶
"Getting access to the component" on page 43.
▶
"Removing the top HDD cage" on page 46.
Removing the heat sink
▶
Remove the heat sink, see "Removing the heat sink" on page 136.
▶
Remove the residual thermal paste from the CPU surface.
▶
Clean the CPU surface using a lint-free cloth.
Installing the heat sink
▶
Remove the protective cover from the heat sink.
▶
Install the heat sink, see "Installing the heat sink" on page 146.
Concluding steps
▶
"Installing the top HDD cage" on page 52.
▶
"Reassembling" on page 50.
▶
"Connecting the power cord" on page 56.
▶
"Switching on the server" on page 57.
▶
"Installing the bay cover" on page 58.
Processor (CPU)
TX1310 M5 Upgrade and Maintenance Manual 149
To Next Page
Loading...
Need help?
General