02–TX150S2–38 July 2004 U41057-J19-Z146-1-76
Initial operation and operating Installation and initial operation
Other power ON/OFF possibilities
In addition to using the ON/OFF button, the server can also be switched
ON/OFF as follows:
– Specified switch-on/switch-off time
With ServerView it is possible to set a particular time, at which the server will
be switched on or off.
– Modem signal (ring indicator)
The server is switched ON via an internal or external modem.
– Wake On LAN (WOL)
The server is switched ON by a command via the LAN (Magic Package).
– After a power failure
The server automatically switches ON following a power failure (depending
of the settings in the BIOS).
– Power button override function
You can switch off the system by pressing the ON/OFF button about 4-5
seconds.
This may cause data to be lost!
– IPMI
The server is switched ON by an IPMI console
via COM1 or RJ45.
!
To Next Page
Loading...
