U41057-J19-Z146-1-76 July 2004 02–TX150S2–37
Installation and initial operation Initial operation and operating
© Siemens Nixdorf Informationssysteme AG 1995 Pfad: P:\02-systemeinheiten\TX150S2\TX150S2-e\TX150S2-e.k02
Switching the server on and off
When after the switching on of the server only flickering stripes are
displayed on the screen, switch off the server immediately. See also
page 02-TX150S2-70.
The ON/OFF button does not disconnect the server from the line voltage.
To disconnect the line voltage completely, unplug the power plug.
Switching on
The power-on indicator lights orange (standby mode).
Ê Press the ON/OFF button on the front side of the device.
First system installation
Insert the ServerStart CD and any available floppy configuration disk, and restart
the device. Make the configuration of the Server with ServerStart.
Operating system already installed
The server is switched on, performs a system test and boots the operating
system.
Please note that the memory size displayed during the system test varies
according to the PCI slot equipment.
Switching off
The power-on indicator lights green.
Ê Shut down the operating system.
Ê Press for a short time the ON/OFF button on the front side of the server.
The server switches OFF and goes to standby mode. The power-on
indicator lights orange.
If the server cannot be switched off by this, an error has occured in
the server. By pressing the ON/OFF button longer than four seconds
the server will be switched off in any case (power button override).
!
i
To Next Page
Loading...
Need help?
General