Fujitsu Scan Snap S1300i User Manual

How to Load Documents
33
How to Load Documents
Load documents in the ScanSnap in the following procedure.
For details about documents that can be loaded, refer to "Documents for Scanning" (page 31).
1. If you are loading multiple sheets, check the number of sheets.
The maximum number of sheets in the ScanSnap is as follows:
For A4 or smaller sizes: Up to 10 sheets can be loaded (with paper weight of 80 g/m²
[20 lb] and thickness of the document stack under 1 mm).
2. Fan the documents.
1. Hold both ends of the documents and fan them a few times.
2. Rotate the documents by 90 degrees and fan them in the same manner.
3. Straighten the edges of the documents and slightly displace the top
edges at an angle.
ATTENTION
If you try to scan more than the maximum amount that can be loaded, the following problems may
occur:
z Files may not be properly created due to excessive file size.
z Paper jams may occur.
ATTENTION
Paper jams or damage to documents may occur if you scan the documents without aligning the
edges first.
Back
Back
at an angle
Feed direction

Fujitsu Scan Snap S1300i Specifications

General

Optical Resolution	600 dpi
ADF Capacity	10 sheets
Interface	USB 2.0
Color Depth	24-bit
Duplex Scanning	Yes
Scanning Method	CIS (Contact Image Sensor)
Scanner Type	Sheetfed
Max Document Size	A4
Scan Speed	12 ppm (simplex), 24 ipm (duplex)
Dimensions	284 x 99 x 77 mm
Weight	1.4 kg
Supported Operating Systems	Windows, macOS
Power Source	USB Bus Power