Fujitsu Scan Snap S1300i User Manual

Cleaning the Inside of the ScanSnap
447
How to perform cleaning
1. Unplug the cables from the ScanSnap.
2. Pull the ADF release tab to open the ADF top section.
3. Clean the following locations with a cloth moistened with Cleaner F1.
ATTENTION
z Do not use water or mild detergent to clean the inside of the ScanSnap.
z It may take a long time for Cleaner F1 to dry if an excessive amount is used. Moisten the cloth
with moderate quantity.
Wipe off the cleaner completely to leave no residue on the cleaned parts.
ADF release tab
ADF top section
ADF paper chute (cover)
Pick spring (metal part)
*gray part
Idler roller (×4)
Glass (×2)
(including the one on the ADF
top section)
Pick roller
White backing strip (×2)
(including the one on the ADF
top section)
Pad assy

Fujitsu Scan Snap S1300i Specifications

General

Optical Resolution	600 dpi
ADF Capacity	10 sheets
Interface	USB 2.0
Color Depth	24-bit
Duplex Scanning	Yes
Scanning Method	CIS (Contact Image Sensor)
Scanner Type	Sheetfed
Max Document Size	A4
Scan Speed	12 ppm (simplex), 24 ipm (duplex)
Dimensions	284 x 99 x 77 mm
Weight	1.4 kg
Supported Operating Systems	Windows, macOS
Power Source	USB Bus Power