Fujitsu Scan Snap S1300i User Manual

Cleaning the Inside of the ScanSnap
449
5. Clean the feed roller and the eject roller with a cloth moistened with
Cleaner F1.
z Feed roller (× 2)
Press the [Scan] button to rotate the roller. Gently wipe the dirt and dust off while
taking care not to damage the surface of the rollers. Make sure that it is cleaned
properly because residue on the roller will affect the feeding performance.
z Eject roller (× 2)
Press the [Scan] button to rotate the roller. Gently wipe the dirt and dust off while
taking care not to damage the surface of the rollers. Make sure that it is cleaned
properly because residue on the roller will affect the feeding performance.
ATTENTION
z Do not use water or mild detergent to clean the inside of the ScanSnap.
z It may take a long time for Cleaner F1 to dry if an excessive amount is used. Moisten the cloth
with moderate quantity.
Wipe off the cleaner completely to leave no residue on the cleaned parts.
HINT
Pressing the [Scan] button seven times will rotate the feed rollers and the eject rollers one
revolution.
Eject roller (×2)
Feed roller (×2)

Fujitsu Scan Snap S1300i Specifications

General

Optical Resolution	600 dpi
ADF Capacity	10 sheets
Interface	USB 2.0
Color Depth	24-bit
Duplex Scanning	Yes
Scanning Method	CIS (Contact Image Sensor)
Scanner Type	Sheetfed
Max Document Size	A4
Scan Speed	12 ppm (simplex), 24 ipm (duplex)
Dimensions	284 x 99 x 77 mm
Weight	1.4 kg
Supported Operating Systems	Windows, macOS
Power Source	USB Bus Power