XG Series User's Guide Chapter 5 Command Reference
VLAN Information Settings
180
You can expand the upper limit to use "resource filter distribution" command and change
resource distribution.
Note 4.
Up to 800 commands can be set for the entire device, including the definitions which refer
to ACL such as "ether macfilter", "ether qos aclmap", "vlan macfilter", "vlan ip6filter",
"vlan qos aclmap", "vlan ip6qos aclmap", "lan ip filter", "lan ip dscp", "lan ip6 filter", "lan
ip6 dscp" and "serverinfo filter" commands.
Default It is assumed that this option has not been set.
5.3.4.2 vlan qos aclmap move
Function Change the priority of QoS for VLAN
Available Model XG0224 / XG0448 / XG0440DC / XG0440DCR / XG2600
Syntax vlan <vid> qos aclmap move <count> <new_count>
Options
<vid>
•
VLAN ID
Specify the VLAN ID with a decimal value from 1 to 4094
<count>
•
Priority
Specify the priority with a decimal value
<new_count>
•
New Priority
Specify the new priority with a decimal value
Use Mode Configuration mode (admin class)
Explanation Change the priority of QoS definition per VLAN
If the current priority is set as <count>, change the priority of this definition to
<new_count>. When the definition is changed, the priority is renumbered.
Default N/A
Range Model
0 to 511 XG0224 / XG0448 / XG0440DC / XG0440DCR
0 to 63 XG2600
To Next Page
Loading...
