Fujitsu XG0224 - Egress Rate Control (XG2600 Only)

XG Series User's Guide Chapter 4 Switch Functions and their Configuration
Basic Switch Functions
64
• XG0224 / XG0448 / XG0440DC / XG0440DCR
4.1.6 Egress Rate Control (XG2600 Only)
It is possible to set an egress rate-limiting value for each port in approximately 40Mbps increments.
To set an egress rate-limiting value, carry out the following procedures in "admin" Operation mode.
Command Task
XG0224# configure Switch to Configuration mode.
XG0224(config)# ether 1-5 mac storm 20000000
discard close
Enable storm control, set threshold 20000000 pps, set "discard"
when broadcast traffic exceeds the threshold, set "close" when
multicast traffic exceeds the threshold.
XG0224(config)# commit Apply the configuration.
XG0224(config)# save Save the configuration.
XG0224(config)# exit Switch to Operation mode.
Command Task
XG2600# configure Switch to Configuration mode.
XG2600(config)# ether 1-5 ratecontrol 8000m Specify an egress rate limiting value by 8000M bps for port 1-5.