Fujitsu XG0224 - Snmp User Notification

XG Series User's Guide Chapter 5 Command Reference
Device Information Settings
277
5.15.1.19 snmp user notification
Function Set a trap notification host address.
Available Model XG0224 / XG0448 / XG0440DC / XG0440DCR / XG2600
Syntax snmp user [<number>] notification [<addr_number>] <address>
Options
<number>
•
User definition number
Specify a user definition number with a decimal value from 0 to 7.
The default is 0.
<addr_number>
•
Trap notification host definition number
Specify a trap notification host definition number with a decimal value from 0 to 7.
The default is 0.
<address>
•
Trap notification host address
Specify an IP address of the host, which is subject to trap notification, in the
XXX.XXX.XXX.XXX format, where "XXX" indicates a 3-digit decimal value.
The allowable range is as follows:
1.0.0.1 to 126.255.255.254
128.0.0.1 to 191.255.255.254
192.0.0.1 to 223.255.255.254
Use Mode Configuration mode (admin class)
Explanation Set a trap notification host address under SNMPv3. Up to eight addresses can be
defined for this device, including the ones set in the "snmp user address" command.
Default It is assumed that no trap notification host address is set.