XG Series User's Guide Chapter 5 Command Reference
Interface Counter, Log, Statistics, and Status Display Commands
441
1) Interface name
2) MTU size
3) Interface flag
The interface flag is displayed by any of the following character strings.
UP : Operating.
BROADCAST:
An available broadcast address is being established.
LOOPBACK : Loopback.
POINTOPOINT:
Point-to-point link.
RUNNING : System resources are being allocated.
PROMISC : Operating in promiscuous mode.
SIMPLEX : Device cannot receive own packets that it has sent.
MULTICAST : Currently supporting multicast.
4) Type
The interface type is displayed by any of the following character strings.
port vlan : Port VLAN
protocol vlan : Protocol VLAN
loopback : Loopback interface
VLAN ID: The VLAN ID is displayed.
MAC address:The MAC address used for the interface is displayed.
Status :The interface status and the clock time when the interface
entered in this status are displayed.
up : Available
down : Unavailable
IP address/masklen:
The IPv4 address of the interface is displayed.
IPv6 address/prefixlen:
The IPv6 address of the interface is displayed.
As needed, the following are displayed after the IPv6 address.
tentative : Indicates that the DAD process has not yet been executed.
duplicated : Indicates that the address is unavailable because a duplicate
address has been detected.
autoconfig : Indicates that the address is an auto-configured address.
To Next Page
Loading...
