12.1 Updating the Communication Unit Software
12-12
12.1.6 Updating the Comm Unit Software using a Single LAN Port
To be applied for updating the Communication unit: Comm Unit (HUB, MODEM)
** It can also be applied for updating the Handset or Incoming indicator **
Step-1. PC Network Connection Settings
1) Open Network connection, open Internet protocol (TCP/IP) properties, and set the IP
address.
Set “192.168.1.2” for the IP address, and set “255.255.255.0” for the subnet mask.
This IP address is the IP address for the PC connected for normal mode.
Then, open Detailed settings (v).
To Next Page
Loading...
