Furuno FELCOM 250

 12.3 BDE Software Updating Tool
12-16
12.3 BDE Software Updating Tool
12.3.1 The Software Tool Screen while the Updating Procedure
is in Process

1. When updating Comm unit
When updating has started (while in maintenance mode), all LEDs will be blinking at
the interval of 1 second excluding the POWER LED for the Communication unit. When
all software for “Comm unit” is to be updated, it will take approx. 10 minutes to
complete. 

If HUB CPU is detected,
the IP address for the HUB
CPU will be displayed.

MAINT: Waiting for
maintenance mode

Forward the software file for
the Modem.

Write the software for the
Modem.

Forward the software
file for the Hub.
