Furuno FELCOM 250

 Contents
C-10
10.6.3 Echo canceller···················································································10-31
10.6.3.1 Extension (Only analog phone): Analog port 1 to Analog port 4 ·····10-31
10.6.3.2 Outside call·················································································10-32
10.6.4 Restart·······························································································10-32
10.7 LED and DIP Switch for the Communication unit·····································10-33
10.7.1 The Panel LED for the Communication unit ······································10-33
1. Transitions of the Status LED for when the power is turned on ············10-33
2. LAN Port·······························································································10-34
10.7.2 Board LED and DIP Switch for the Communication unit····················10-35
1. POWER board (16P0266) ····································································10-35
2. MODEM board (16P0274)····································································10-36
3. HUB Board LED ···················································································10-38
10.8 Checking the Incoming indicator : FB-3000 ·············································10-40
1. LAN LED·······························································································10-41
2. Initializing the Incoming indicator··························································10-41
10.9 Initializing·································································································10-42
10.9.1 Initializing the Communication unit····················································10-42
1. Executing initialization from the Web MMI············································10-42
2. Reset the hardware of the Communication unit····································10-43
3. Items initialized in the Communication unit···········································10-44
10.9.2 Initializing the Handset ······································································10-45
1. Reboot the Handset··············································································10-45
2. Executing the initialization process from the Handset menu·················10-45
3. Reset the Handset hardware································································10-46
4. Items initialized in the Handset·····························································10-46
10.9.3 Initializing the Incoming indicator·······················································10-47
1. Reboot the software··············································································10-47
2. Reset the hardware ··············································································10-47