EasyManuals Logo

Furuno FELCOM 250 Service Manual

Furuno FELCOM 250
462 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #56 background imageLoading...
Page #56 background image

Contents
C-14
Q16. Is there a specific direction specified for installing the Antenna? ··············13-2
Q17. Can I shorten the Antenna coaxial cable?·················································13-3
Q18. Can I use Inmarsat B or Fleet 77 Antenna coaxial cable?
Is the Antenna installation pitch the same? ·········································13-3
Q19. Can I also use the conventional analog devices? ·····································13-3
Q20. Can I establish parallel connection using Analog phone? ·························13-3
Q21. Are external input signals such as Gyro or GPS required?·······················13-3
Q22. Please describe the specifications
for the LAN port of the communication unit. ········································13-3
Q23. Can we substitute the LAN cable with a MP-xx cable?·····························13-3
Q24. Can I make the settings for the buzzer sound
for the incoming message/call buzzer? ···············································13-4
Q25. What is L-Band OUT used for?·································································13-4
Q26. Which SW HUB with what specification is available?································13-4
Q27. Is there any power switch for the Handset and the Incoming indicator? ···13-4
Q28. The system rejects the password for Administrator's mode. ·····················13-4
Q29. Is there any method to save the System information
or the Status information displayed upon the Web MMI? ····················13-4
Q30. The Elevation angle for Fleet 77 and FB are different.······························13-4
Q31. Is it possible to apply restrictions onto the phone calls?····························13-4
Q32. Is it possible to apply restrictions onto
the connections for PS communication? ·············································13-5
Q33. Is there any way I can save the system log in the PC?·····························13-5
Q34. Is there any specific range of IP addresses available
for being allocated? ·············································································13-5
Q35. Is there any way to allocate a Static IP address?······································13-5
Q36. What value is the normal signal strength? ················································13-5
Q37. No Communication····················································································13-5
Q38. What would happen if the GPS data is interrupted?··································13-6
Q39. The Ready LED is blinking at an interval of 1 second.······························13-6
Q40. Is there any way to restore the settings to factory settings?······················13-6
Q41. What do I have to be note about when replacing boards? ························13-6
Q42. Where is the AZ direction of the antenna displayed?································13-6
Q43. Where can I make the settings for the Global IP address? ·······················13-6
Q44. What would happen if Antenna blocking occurs?······································13-7

Table of Contents

Other manuals for Furuno FELCOM 250

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Furuno FELCOM 250 and is the answer not in the manual?

Furuno FELCOM 250 Specifications

General IconGeneral
BrandFuruno
ModelFELCOM 250
CategoryMarine GPS System
LanguageEnglish

Related product manuals