Furuno NAVnet TZtouch2 - Page 252

10. CAMERA/VIDEO/EXTERNAL EQUIPMENT
10-7
10.3.2 How to adjust the image size
You can adjust the image size from the pop-up menu.
1. In the camera mode, tap the
screen to show the pop-up menu.
The items shown on the pop-up
menu depend on the camera con-
nected.
2. Tap the camera display to adjust.
For multiple camera installation,
see section 10.3.3.
3. Tap [Stretch] or [Fit].
[Stretch]: Shrink or enlarge the
image to fit the monitor’s width.
[Fit]: Shrink or enlarge the image to fit the monitor’s height. The aspect ratio is
kept, so a black bar appears on the right and left sides of the picture. This is nor-
mal; it is not a sign of malfunction.
10.3.3 How to switch your video inputs
If you have more than one camera installed, you can switch your video inputs from the
camera screen.
1. On a camera display, tap the screen to show the pop-up menu.
2. Tap the display name to show the pop-up menu for selection of camera display.
3. Tap the camera display desired, then tap <.
Image size
selections
Display
name