Furuno NAVnet TZtouch2 - Page 325

15. OTHER FUNCTIONS
15-6
[Graphic Instruments Setup] - [Propulsion Engine]
[Graphic Instruments Setup] - [Other Engine]
CZONE section
MANUAL FUEL MANAGEMENT section
Menu Item Description Options (setting range)
[Max. RPM] Set the maximum rpm of your engine to
show on the RPM display.
1 rpm to 20,000 rpm
[Red Zone Oil Pressure] Set the starting value for the red zone area
of the oil pressure meter.
0 kPa to 998 kPa
[Max. Oil Pressure] Set the maximum oil pressure of your
engine.
1 kPa to 999 kPa
[Min. Temperature] Set the minimum temperature for your
engine.
0.00°C to 99.00°C
[Red Zone Temperature] Set the starting value for the red zone area
of the engine temperature indicator.
0.01°C to 999.00°C
Menu Item Description Options (setting range)
[Max. RPM] Set the maximum rpm of your engine to
show on the RPM display.
0 rpm to 20,000 rpm
[Red Zone Oil Pressure] Set the starting value for the red zone area
of the oil pressure meter.
0 kPa to 999 kPa
[Max. Oil Pressure] Set the maximum oil pressure of your
engine.
0 kPa to 999 kPa
[Min. Temperature] Set the minimum temperature for your
engine.
0°C to 99°C
[Red Zone Temperature] Set the starting value for the red zone area
of the engine temperature indicator.
0°C to 999°C
Menu item Description
[Add Default CZone
Pages]
Create, edit C-Zone pages.
[CZone DIP Switch
Settings]
Set this unit’s DIP switches. For the serviceman. Do not change the set-
tings.
Menu item Description
[Reset Instrument Pag-
es]
Resets all instrument pages to default. [OK], [Cancel]
[Reset Default Set-
tings]
Resets applicable settings to default. [OK], [Cancel]
Menu item Description Options (setting range)
[Total Fuel Capacity] Enter the total fuel capacity of your
tank(s).
0 to 9,999(L).
[Manual Fuel Manage-
ment]
Set to [ON] for manual fuel manage-
ment. See the Operator’s Manual.
[OFF], [ON].