Furuno NAVnet TZtouch2 - Page 326

15. OTHER FUNCTIONS
15-7
IF-NMEAFI SETUP section
DATA ACQUISITION section
INTERNAL GPS SETUP section (TZTL12F/TZTL15F only)
SC-30 SETUP section
Menu item Description Options (setting range)
[Select IF] Select [IF-NMEAFI] to set the analog data that is input from the IF-NMEAFI.
[Category] Select the category for the analog sensor to
set.
[Wind], [ST800_850], [Fuel],
[FreshWater], [WasteWater],
[LiveWell], [Oil], [BlackWater]
[Resistance Full] The resistance, in Ohms, when the tank is full. 0 (ohm) to 300 (Ohm)
[Resistance Mid] The resistance, in Ohms, when the tank is half
full.
0 (ohm) to 300 (Ohm)
[Resistance Empty] The resistance, in Ohms, when the tank is
empty.
0 (ohm) to 300 (Ohm)
[Capacity] The capacity of the tank. 0 (G) to 2650 (G)
[Fluid Instance] NMEA2000 Instance Number of the tank 0 to 5
[Self test] Test results are displayed.
[Set Hardware To
Factory Default]
Resets the converter selected at
[Select IF] to factory default.
[OK], [Cancel]
Menu Item Description Options (setting range)
[GP330B WAAS Mode] Select [ON] to use the WAAS mode for the
corresponding GPS antenna.
[ON], [OFF]
[WS-200 WAAS Mode]
[Data Source] Select the source for each data to input to the system. If two or more
sources are connected for a data, select one using the pull-down dialog
box. (FURUNO sensors are shown at the upper part of the list.)
[Sensor List] Show the information for sensors connected to your equipment. Also,
you can set a "Nickname" for them here.
[NMEA0183 Output] Select [ON] to output NMEA sentences.
[NMEA 2000 PGN Output] Select [ON] for the PGNs (Parameter Group Number, CAN bus
(NMEA2000) message) to output from the CAN bus port.
[Sky View] Show the condition of GPS and GEO (WAAS) satellites
on the [GPS SkyView] display. The bearing and eleva-
tion angle of all GPS and GEO satellites (if applicable) in
view of your receiver appear. For the serviceman.
Note: The [GPS SkyView] display can also be shown by
tapping the GPS icon (shown right) on the home screen.
Menu Item Description
[WAAS Mode] Set to [OFF] when using external GPS.
Menu item Description Options (setting range)
[WAAS Mode] Select [ON] to use the WAAS mode. [ON], [OFF]
[Heading Offset] Enter the offset value for heading. -180° to +180°
[Pitch Offset] Enter the offset value for pitching. -90° to +90°
[Roll Offset] Enter the offset value for rolling. -90° to +90°