7.4 FELCOM 12
7-9
7.4 FELCOM 12
1) Terminal program
1. While pressing and holding down [Alt] and [Fn], press [F2]. "OK to quit system
Yes/No" appears.
2. Select "Yes" with the cursor, and press [Enter].
"A:¥ > FELCOM12" appears.
3. Insert the program floppy disk.
4. Type [B] [:] and press [Enter].
The prompt, B:¥ > appears.
5. Type “IBINST” and press [Enter].
After a while, "It is completed to install programs to A: ¥>FELCOM12." appears.
And then, the message changes to "B: ¥>".
6. Turn off the unit.
2) Communication unit: CPU-2
The system program for CPU2 in the communication unit is stored onto the flash ROM
U26 on the CPU Board. To update the software;
1. While pressing and holding down [Alt] and [Fn], press [F2]. "OK to quit system
Yes/No" appears.
2. Select "Yes" with the cursor and press [Enter].
"A:¥ > FELCOM12" appears.
3. Insert the floppy disk which contains CPU2 system program.
4. Type [B] [:] and press [Enter]. The prompt "B:¥ >" appears.
5. Type “UP12” and press [Enter].
The message
"About to update FELCOM12 CPU2 software. Press 'Y' to update the software to
165-0118-1xx. If you wish to cancel, press 'N' key" appears.
6. Press [Y].
"Loader Version 6.00 Erase wait: 0 sec Write wait:0 Wait counter = 100
TARGET power ON" appears.
7. Turn off the communication unit and turn it on again.
"Execute STEP1, Execute STEP2, 233096 byte transfer Now Erasing
xxx percent completed" appears.
Note) xxx changes from 000 to 100.
8. After about 5 minutes, erasing will finish with the following indication.
"Finish version update.
B:¥ >"
9. Turn off the terminal and communication units.
To Next Page
Loading...
