7.2 DSC-60
7-6
2) Clearing memory
To clear the memory, complete steps below.
1. After turning on, press S1 (NMI SW) on the CONTROL/MODEM board.
2. Type a password 652111. The typed number is not displayed.
3. Select “ALL CLEAR” by using the down key, and press [ENT].
4. Enter MMSI.
5. With PLEASE POWER DOWN on the screen, turn off the unit and turn it on again.
6.
Carry out system setting.
J7
J6
J1
J3 J8 J9
J4
J5
U5
S1
NMI SW
EEPROM
05P0702
Fig. 7.2.3 Place for NMI switch
on the CPU board
Fig. 7.2.4
Fig. 7.2.5
* * * *
EEROM clear
* * *
NO CLEAR
MMSI CLEAR
ALL CLEAR
****
MMSI entry
****
1 1 1 6 6 0 0 0 0
To Next Page
Loading...
