2.1 MF/HF (150/250W) system
2-8
3) Adjusting output power
The output power is adjusted for “HI”, and “LOW”. Do not adjust output power with
“TUNE”. The antenna coupler is tuned automatically with the TUNE power.
For the output power adjustment, get into the output power adjustment mode, and then
set the power data by turning [FREQ/CH] knob. Power data to be set differs according
to frequency bands in the table below.
Table 2.1.4
Note) Power data for user channel is commonly used for all class of emission.
To Next Page
Loading...
