Furuno RC-1800T - Page 99

7.2 DSC-60
7-5
1) Updating program using IB-581
1. Connect the IB-581 to the DSC-60.
2. Turn on the IB-581, but do not turned on the DSC-60.
3. Terminate the terminal program.
With IB-581 for DP-6, FELCOM 12/81, while press and holding down [Alt] and [Fn],
press [F2].
4. Insert the program floppy disk in the slot.
5. Type B: and press [Enter]. The prompt B:¥> appears.
6. Type “UPDSC” and press [Enter] to upgrade main program. The following message
appears. Type “UPMODEM” and press [Enter] to upgrade modem program.
Program upload utility Version 6.21
Copyright(c) FURUNO ELECTRIC CO., LTD.1997,1998,1999 (T.K)
uppg infile 1 infile 2 p1 p2 p4 p5
p1:Deletion waiting time.
p2:Waiting time to write.
p3:Password output interval.
p4:ID number.(1,2...)
p5:Poer number.(1,2...)
Erase Wait:osec
Wait:o
Wait counter=100
Port no.=1
TARGET POWER ON.
7. After TARGET POWER ON message appears, turn on the DSC-60. “Now Loading”
appears on the DSC screen.
8. The DOS prompt appears after the message “Finish version up.”
9. Turn off the DSC-60, disconnect the IB-581 and turn on the DSC-60 again.
Reading Program Revision Level
To read the program revison level, after carrying out selftest ([3/TEST/DEF]), press
[1/RT/2182] five times while holding down [*/FILE].
Fig. 7.2.2 Reading program revision level
*
DSC-60 dialy test
*
MAIN CPU
MODEM
RCVR1
RCVR2
REMOTE RT
REMOTE DP
: OK VER.01
: OK VER.02
: OK
: OK
: OK FS-1562
: OK DP-6
JAN - 10 - 2000 - 18:20
*
DSC-60 dialy test
*
MAIN CPU
MODEM
RCVR1
RCVR2
REMOTE RT
REMOTE DP
: OK V01.04
: OK V02.13
: OK
: OK
: OK FS-1562
: OK DP-6
JAN - 10 - 2000 - 18:20