Alarm time
OFF, 1~99-minutes
Initial value: 5-minutes
- Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Pre-alarm time
OFF, ON
Initial value: OFF
- Tap (ON)/(OFF).
Grip vibrator type (pattern)
Inhibit(Off), Type 1,2,3
Initial value: Inhibit
- Tap (ON)/(OFF).
Start/Stop
Status display
Timer reset
136
Function
Timer
(Preparation)
Select the "Lap timer" from the timer type list and tap.
1
(Alarm time setting)
Tap the value button of the "Alarm time".
Value input buttons appear on the screen.
Use the [+] and [-] buttons to set the time
amount.
Tap [Vibrate] and select the vibration pat-
tern of the alarm from 3 types of patterns
and disable (OFF).
(Pre-alarm setting)
Tap (ON) or (OFF) of pre-alarm and select ON/OFF.
2
(Timer start operation)
Perform the start and lap count operations with the switch
("Timer start") assigned by function select
switch function.
- How to start by trigger operation.
Tap [OFF] of the trigger to display [Ready]
and wait for the trigger operation. When
you operate the trigger to the forward side,
the timer starts. The stop is the same as
when starting with a switch.
* You cannot start it unless you reset the last lap tim-
er.
If the lap timer is reset, the lap list (page 138) is
also cleared.
3
(Timer stop and lap reset operation)
When the lap count switch or ("Timer re-
set") switch is pressed after the time set by
"Alarm" has elapsed and the lap time, total
time, and average lap time are saved and
checked. (Lap list page 138) If the switch
("Timer reset") set by switch select function
is pressed, the timer is reset.
When a switch is not set, tap [Reset] on
the screen. The timer is reset with a beep-
ing sound.
Using the lap timer
If you start without resetting
the last lap timer, it will be dis-
played.
To Next Page
Loading...
Need help?
General
