FUTABA 7PXR - Receiver system Change & How To Link

HOME Menu Linkage menu Receiver
* Even with the same receiver,
if you change the system, be
sure to link with the receiver
and power cycle the receiver.
(pages 38 to 41)
S-FHSS/FASST T-FHSS T-FHSS SR Mini-Z T-FHSS
38
Initial Set-Up
Receiver system Change & How To Link
First, set up the
"
Receiver
"
function. Setting changes are immediately ref lected.
Next, the transmitter and receiver are linked, and the receiver memorizes the trans
-
PLWWHU,'QXPEHUVRWKDWVLJQDOVIURPRWKHUWUDQVPLWWHUVZLOOQRWEHUHFHLYHG
%HVLGHVZLWKWKH7)+66WHOHPHWU\V\VWHPWKHWUDQVPLWWHUVLPXOWDQHRXVO\PHPR-
UL]HV WKH UHFHLYHU ,' QXPEHUV VR WKDW GDWD IURP RWKHU UHFHLYHUVZLOO QRW EH UHFHLYHG
The method of setting up the receiver system and the method of linking the transmitter and
UHFHLYHUDUHGHVFULEHG5HIHUWRWKH¿JXUHDWWKHULJKWIRUWKHHGLWEXWWRQVXVHG
1
Set the transmitter "PWR" side power switch to ON. From the Home screen, press the
HOME button or tapped [Menu] on the touch panel. Next, select [Receiver] at the Linkage
menu and access the setup screen shown below by tapping the screen.
2
In "Receiver", select and tap the system to be set from T-FHSS SR, T-FHSS, S-FHSS,
FASST. The confirmation screen will be displayed. To execute, tap [Yes] to hear an electronic
sound and finish setting. To cancel, select [No] and touch it. If you change the system, be
sure to link it with the receiver and turn the power on again.