GE LOGIQ 400 - Page 400

GE MEDICAL SYSTEMS
2127661
LOGIQ 400 SERVICE MANUAL

RENEWAL PARTS
6–270
REV 9
6–6–4 Procedures (continued)
(C) Installing 3.5–Inch HDD Assy (continued)
20. Connect the CB45N cable with the 3.5–inch HDD Assy. Refer to ILLUSTRATION 6–154.
21. Connect another side of the CB45N cable to the CB46 cable.
Note
The CB45N and CB46 cables are not included in the LOGIQ 400CL. It is not necessaey to install
those cables to the LOGIQ 400CL console.
22. Set the 3.5–inch HDD Assy on the HDD Holder2 Assy. Refer to ILLUSTRATION 6–154.
23. Screw four screws supplied with the HDD Change Kit to install the 3.5–inch HDD Assy to the HDD Holder2 Assy.
Refer to ILLUSTRATION 6–154.
INSTALLING 3.5–INCH HDD ASSY ON HDD HOLDER2 ASSY
ILLUSTRATION 6–154
Note
The HDD LED Assy is not available on the console with the new type of 3.5–inch HDD Assy (Quan-
tum FireBall 1280S). In this case, the CB45N cable is not used. Hold the CB46 cable onto the
metal frame with an adhesive tape.