GE LOGIQ 400 - Setting DIP Switches; Operational Check-Out

GE MEDICAL SYSTEMS
2127661
LOGIQ 400 SERVICE MANUAL
TM
8–20 OPTIONS
REV 4
8–2–8 Connecting Cables (Continued)
Note
In case of B/W monitor system, the header information data may be displayed on the playback screen
when using the S Video connection. It is recommended that the Color Composite connection is used.
Note
The LOGIQ 400CL does not provide the VCR remote control function. It is not necessary to connect
the RS–232C cable for the remote control with the LOGIQ 400CL console.
8–2–9 Setting DIP Switches
1. Set the DIP switches located on the rear panel of the video cassette recorder as shown in ILLUSTRATION 8–13.
Note
The LOGIQ 400CL does not provide the VCR remote control function. Set the DIP switched as
shown in ILLUSTRATION 8–13.
DIP SWITCH SETTINGS
ILLUSTRATION 8–13
8–2–10 Operational Check-out
1. Plug in the system and power the system ON.
2. Make sure that the CTL/MENU switch located at the front of VCR is set to the CTL position (upper side).
CTL/MENU SWITCH SETTING
ILLUSTRATION 8–14
Note
The VCR does not perform properly when the CTL/MENU switch is set to MENU position.