GE MAC 1600

9-22 MAC™ 1600 2028451-182B
System Configuration
Service Provider Number Identifies the service provider’s access telephone number.
PIN Number Identifies the personal identification number to enter.
Outside Line Identifies any access numbers that must be dialed to reach
an outside line.
Manual Dialing Determines whether the system will automatically dial. If
this field is checked, the connection must be made
manually. If this field is cleared, the system automatically
dials and you must complete the following fields:
 Dialing Method
 Dialtone Required
 PIN Dialing
Page 4
Cardiograph Device Name Identifies the name that identifies the MAC 1600 unit on the
network. By default, the value is set to
GE_<serial number>. A valid network device name
contains between 1 and 20 alphanumeric and underscore
characters. The first character must be a letter.
This field is available only if a LAN option has been
activated.
Serial/IP Redirector Listen
Port
Identifies the port the device should listen to for incoming
serial/IP connections. These communications must match
the values defined on the transmitting MUSE system.
Obtain an IP address
automatically (DHCP)
Determines whether the MAC 1600 device will
automatically receive an IP address from the network.
If this box is checked and LAN communication to a MUSE
system is enabled, the DHCP server must be configured to
reserve a static IP address for the MAC1600. Contact your
network administrator for assistance.
If this field is checked, the IP Address, Netmask, and
Gateway fields are display-only. If this field is cleared, you
must complete those fields.
IP Address Identifies the IP address of the MAC 1600 device. If the
Obtain an IP address automatically (DHCP) field is
cleared, you must define a unique IP address.
Netmask Identifies the netmask of the MAC 1600 device. If the
Obtain an IP address automatically (DHCP) field is
cleared, you must define a netmask.
Gateway Identifies the IP address of the gateway to be used by the
MAC 1600 device. If the Obtain an IP address
automatically (DHCP) field is cleared, you must enter the
gateway’s IP address.
Field Comment