GE MAC 1600

System Configuration
2028451-182B MAC™ 1600 9-31
Date/Time Setup
The Date/Time Setup function allows you to configure the MAC 1600
system’s date and time settings.
To reach Date/Time Setup from the MAC 1600 Main Menu, press F5
(System Configuration) > F6 (More) > F6 (More) > F6 (More) > F1 (Date/
Time Setup).
The following table identifies the settings on Date/Time Setup.
Setup Utilities
The setup utilities available in System Configuration allow you to print,
switch, export, and import system settings and export the audit trail.
Print Setup Report
The Print Setup Report utility prints a report of individual settings or the
complete system settings. You may use the report to verify that all MAC
1600 devices are configured identically or to reference if you need to
reconfigure a device.
Use the following instructions to print a setup report.
1. From the Main Menu, press F5 (System Configuration) > F6 (More) >
F3 (Print Setup Report).
2. On the Print Setup Report window, select the report to print.
Field Comment
Date Sets the current system date. The format of the fields
depends on the date format selected on Country Setup.
For more information, refer to “Country Setup” on
page 9-23.
Time Sets the current system time. If the Automatically
Synchronize with Time Server field is set on Basic Setup,
any changes made to the time will be overwritten during
the next synchronization. For more information, refer to
“Basic Setup” on page 9-2.
Time Zone Identifies the time zone in which the device is located.
Available only if Automatically synchronize with Time
Server is enabled in Basic Setup. Refer to “Basic Setup” on
page 9-2 for more information.
Adjust clock for daylight
savings time
Determines whether the system will automatically adjust
the system time for daylight savings time. Available only if
Automatically synchronize with Time Server is enabled in
Basic Setup. Refer to “Basic Setup” on page 9-2 for more
information.