1-6 MAC™ 1600 2028451-182B
Introduction
WARNING
SHOCK HAZARD — Improper use of this device
presents a shock hazard. Strictly observe the following
warnings. Failure to do so may endanger the lives of the
patient, the user, and bystanders.
When disconnecting the device from the power line,
remove the plug from the wall outlet first, before
disconnecting the cable from the device.
Otherwise there is a risk of coming in contact with line
voltage by inadvertently introducing metal parts in the
sockets of the power cord.
Devices may be connected to other devices or to parts of
systems only after making certain that there is no danger
to the patient, the operators, or the environment as a
result. Standards IEC 60601-1-1/EN60601-1-1 must be
complied with in all cases.
WARNING
SITE REQUIREMENTS — Do not route cables in a way
that they may present a stumbling hazard.
For safety reasons, all connectors for patient cables and
leadwires are designed to prevent inadvertent
disconnection, should someone pull on them.
For devices installed above the patient, adequate
precautions must be taken to prevent them from dropping
on the patient.
WARNING
TREADMILLS — Avoid rapid changes in treadmill
speed and/or grade during a stress test.
CAUTION
ACCESSORIES (SUPPLIES) — To ensure patient
safety, use only parts and accessories manufactured or
recommended by GE.
Parts and accessories used must meet the requirements of
the applicable IEC 60601 series safety standards and
essential performance standards, and/or the system
configuration must meet the requirements of the IEC
60601-1-1 medical electrical systems standard.
To Next Page
Loading...
Need help?
General
