GE Multilin D400 User Manual

116 GE INFORMATION D400 SUBSTATION GATEWAY INSTRUCTION MANUAL
CHAPTER 9: ABOUT THE D400 APPLICATIONS
D400 applications
This section lists the configurable applications that may be available for your D400. The
applications available to you depend on your D400 firmware version and configuration.
You set up and run the applications using a variety of tools and utilities that are provided
with the D400.
Applications available with D400 redundant operation
Table 27 lists the D400 applications that are available with the:
• Warm Standby redundancy mode
• Hot Standby redundancy mode.
Not all protocols are supported in the Hot Standby Redundancy mode.
Carefully review product documentation and configure Redundancy accordingly.
Table 27: Redundant D400 operation - available applications
Application Name Redundancy Mode License
required
Warm Standby Hot Standby
Client Application (DCA)
DNP3
 
Generic ASCII
 Not Available
IEC® 60870-5-101+104
 Not Available
IEC 60870-5-103
 Not Available
IEC 61850
 
Yes
Hydran®
 Not Available
SEL Binary
 Not Available
MODBUS®
 
D.20 Network Client
 
SNMP
 Not Available
Server Application (DPA)
IEC 60870-5-101+104
 Not Available
DNP3
 
MODBUS®
 Not Available
Automation Application (DTA)
Alarm
 
Calculator
 
Data Logger
 Not Available
System Point Manager
 
LogicLinx®
 
Yes
ARRM (Automated Record Retrieval Manager)
 Not Available
Yes
Load Shed and Curtailment
 Not Available
Analog Reports
 Not Available
Tools/Utilities
Runtime HMI
 
Online Configuration Tool
 
Offline Configuration Tool
 

GE Multilin D400 Specifications

General

Brand	GE
Model	Multilin D400
Category	Gateway
Language	English