GE Multilin D400 User Manual

CHAPTER 13: SERVICING THE D400
D400 SUBSTATION GATEWAY INSTRUCTION MANUAL GE INFORMATION 167
Figure 67: Replace the main CompactFlash card
To change the User
CompactFlash card
1. Power down the D400.
2. Using a Phillips Screwdriver, remove the screws from the CompactFlash slot cover
located on the front panel of the D400 main module.
3. Press the Eject button to eject the CompactFlash card.
4. Insert the new CompactFlash card into the slot.
5. Replace the CompactFlash slot cover and secure it with the screws.
6. Power up the D400.
Figure 68: Change the user CompactFlash card
Replacing the power supply
The D400 may contain one or two power supplies (AC-DC and/or DC/DC) in the power
supply slots. The D400 may be supplied with an optional redundant power supply (in Slot 2)
to provide dual hot swappable power supplies. The power supply module is accessible and
easily replaced from the D400 front panel.
Eject button
Connector P2
PC/104-Plus
Ethernet Module

GE Multilin D400 Specifications

General

Brand	GE
Model	Multilin D400
Category	Gateway
Language	English