134 GE INFORMATION D400 SUBSTATION GATEWAY INSTRUCTION MANUAL
CHAPTER 12: USING THE D400 LOCAL CONFIGURATION UTILITY
Start the D400 configuration utility
To start the D400 configuration utility:
1. At the D400#>> command prompt, type d400cfg.
2. Press the Enter key.
Result: The
D400 Configuration Utility Menu appears.
3. Type a function number.
The Configuration Utility menu items (see Figure 59) are described in the following
sections:
– 1. Configure Authorization; see page 136
– 2. Configure Network Settings; see page 136
– 3. Configure Network Interfaces; see page 137
– 4. Configure Secure Access; see page 140
– 5. Configure Firewall; see page 143
– 6. Configure Host Names; see page 145
– 7. Configure Time & Time Sync; see page 146
– 8. Reset System Logs; see page 146
– 9. Reset mSQL Database Tables; see page 147
– 10. Reset NVRAM; see page 147
– 11. Rest File Persistence Data; see page 148
– 12. Local HMI; see page 148
– 13. Configure Sync Manager; see page 151
– 14. Redundancy; see page 154
– 15. Power Supply; see page 156
– 16. ARRM; see page 156
– 17. Suppress Forced Qualities To Masters; see page 157
– 18. Restore Factory Default; see page 157
– 19. Reboot D400
4. Press the Enter key.
Result: A sub-menu for the selected function appears.
To Next Page
Loading...
