GE Multilin D400 User Manual

150 GE INFORMATION D400 SUBSTATION GATEWAY INSTRUCTION MANUAL
CHAPTER 12: USING THE D400 LOCAL CONFIGURATION UTILITY
Enable standby local
HMI redirects to active
D400 procedure
To enable Standby Local HMI redirects to Active D400:
1. Log into the D400 Utilities page.
Result: The
D400 #>> command prompt appears.
2. Type d400cfg and press Enter.
Result: The D400 Configuration Utility menu appears.
3. Select option 12. Local HMI.
Result: The Local HMI sub-menu appears.
4. Select option 8. Standby Local HMI (Redundancy).
Result: The following prompt appears:
IMPORTANT !
* Currently Redundancy configuration is Disabled.
* Active D400 Access from Standby Local HMI configuration is
applicable only when Redundancy is Enabled.
* Number of simultaneous users must be a minimum of 2 for
the configured user role in both D400s, which can be
configured from HMI (Configuration > Systemwide >
AccessManager) menu.
Currently Active D400 Access from Standby Local HMI is
Disabled.
Are you sure you want to Enable Active D400 Access from
Standby Local HMI [Y/N]?:
5. If you enter Y, then this feature is enabled.
If you enter N, then this feature is not enabled.
Disable standby local
HMI redirects to active
D400 procedure
To disable Standby Local HMI redirects to Active D400:
1. Log into the D400 Utilities page.
Result: The
D400 #>> command prompt appears.
2. Type d400cfg and press Enter.
Result: The D400 Configuration Utility menu appears.
3. Select option 12. Local HMI.
Result: The Local HMI sub-menu appears.
4. Select option 8. Standby Local HMI (Redundancy).
Result: The following prompt appears:
Currently Active D400 Access from Standby Local HMI is
Enabled.
Are you sure you want to Disable Active D400 Access from
Standby Local HMI [Y/N]?:
5. If you enter Y, then this feature is disabled.
If you enter N, then this feature is not disabled.

GE Multilin D400 Specifications

General

Brand	GE
Model	Multilin D400
Category	Gateway
Language	English