GE Multilin G100 - DP Display Port

G100 Instruction Manual
GE Information
994-0155-1.00-1
57
When configured as B006 the clock requires a corresponding configuration where the year and quality are
included in the IRIG-B signal. If the clock is not configured to provide the year the G100 will show the year 2000.
This Port is isolated from the rest of system with an isolation voltage of 1.5kV AC / 2.1kV DC.
The supported levels are compliant to TTL or TIA232, selectable by an internal jumper:
Green PIN HEADER 1x3 Male 180° 2.0mm DIP
Table 23: IRIG-B input signal selection TTL/RS-232
Jumper
JIRIGB1
DESCRIPTION
1-2
TTL
2-3
RS232
G100 does not support PTP IEEE1588.
NTP and SNTP are supported.
DP Display Port
The top panel of the unit provides one DisplayPort
TM
connector.