8 994-0155-1.00-1 GE Information
About this Document
Purpose
This manual provides information about installing, setting up, using and maintaining your G100 Substation
Gateway. This manual does not provide any procedures for configuring the G100 software
Intended Audience
This manual is intended for use by field technicians and maintenance personnel who are responsible for the
installation, wiring and maintenance of SCADA equipment. This guide assumes that the user is experienced in:
• Electrical utility applications
• Electrical wiring and safety procedures
• Related other manufacturers’ products, such as protective relays and communications equipment
Additional documentation
For further information about the G100, refer to the following documents.
• G100 Substation Gateway Quick Start Guide (SWM0116)
• MCP Software Configuration Guide (SWM0101)
• Configuring UEFI Settings on G100 User Guide (SWM0122)
• Module layouts, as available
• G100 Online Help
How to use this document
This document describes how to install the G100.
Procedures are provided for all component options available for the G100. The components included in your
G100 depend on what was ordered for your substation application. Follow only the procedures that apply to your
G100 model.
To check what options are included in your G100, see Order Code.
To Next Page
Loading...
Need help?
General
