GE Venue R1

D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
Chapter 4 - General Procedures and Functional Checks 4-7
PRELIMINARY
• For Venue R2 systems running software version 302.x.x:
Set the power switch, located on the rear lower part of the system, to the OFF position.
Wait for 10 seconds and re-set the power switch to the ON position.
• Wait for about 15 Sec before the System is operational.
•Cancel
Use this button to exit from the System-Exit menu and return to the previous operation.
Figure 4-5 Power ON/OFF Switch and Power (AC IN) Socket - Rear Panel
(AC IN)
Power
ON/OFF Switch
Power Inlet