8-74 Section 8-5 - Electronic Boards- Replacement Procedures
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
6.) Loosen the 2 screws that secure the metal cover of the TRx32 Box, and carefully pull the T-TRx
box towards you.
8-5-4-5 T-TRX Box Installation Procedure
1.) Close the T-CFE metal cover and fasten the retaining screws.
2.) Reconnect the cables (previously disconnected).
3.) Close the Front End door and fasten securely with the two latches:
4.) Refit the following covers: Lower Front eTower, Left side eTower, Right Side eTower and RS Probe
Cover:
:
5) Install all accessories.
6.) Turn ON power to the system.
Figure 8-59 Removing the T-TRX Box
• Right Side eTower Cover Installation Procedure
• Left Side eTower Cover Installation Procedure
• Lower Front eTower Cover Installation Procedure
• RS Probe Cover Installation Procedure
• Accessories - Replacement Procedures
Perform the checks listed in T-TRx Box Replacement Procedure on page 8-217
To Next Page
Loading...
