Chapter 8 - Replacement Procedures 8-85
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
8-6-3-5 Halo Handle Installation Procedure
1.) Mount the Halo Handle on the eTower.
2.) Apply LOCTITE® 243™ on the Halo Handle mounting screws and tighten them.
3.) Install the Riser Cover.
4.) Install the Riser Thermal Cover.
5.) Install the articulated arm.
6.) Install the cockpit (monitor).
7.) Install all accessories.
8.) Turn ON power to the system.
• Riser Cover Installation Procedure
• Riser Thermal Cover Installation Procedure
• Arm Installation Procedure
• Cockpit (Monitor) Installation Procedure
• Accessories - Replacement Procedures
Perform the checks listed in Halo Handle Replacement Procedure on page 8-218
To Next Page
Loading...
