GE Venue R1

Chapter 8 - Replacement Procedures 8-109
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
7.) Place the MPB module on a flat surface and disconnect the MPB Rear USB Cable connector to the
MPB J12 Connector.
8.) Using Phillips screwdriver, disconnect the two screws that hold the cable connector to the rear
panel and remove the cable.
Figure 8-92 Disconnecting MPB Rear USB Cable - To MPB J12 Connector
Figure 8-93 Disconnecting MPB Rear USB Cable - To Rear Panel Connector
MPB to Rear USB Cable - To MPB J12 Connector
MPB to Rear USB Cable - To Rear Panel Connector (side 1)
MPB to Rear USB Cable - To Rear Panel Connector (side 2)