Chapter 8 - Replacement Procedures 8-125
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
c.) Using Allen key, remove the two securing screws of the arm side cover.
d.) Slide the left-side arm side cover upwards and remove it.
6.) Cut the tie wraps securing the BE to cockpit cable to the arm left side, and release the cable from
the arm.
7.) Route the cable and its connector downwards through the arm hole.
Figure 8-119 Removing Arm Side Covers
Figure 8-120 Arm Side Cable: Removing Tie Wraps
Figure 8-121 Route Cable Through Arm Hole
To Next Page
Loading...
