Chapter 8 - Replacement Procedures 8-169
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
12.)Refit the following covers: RS Probe Cover, Lower Front eTower, Left side eTower, Right Side
eTower, Upper eTower Front Cover.
13.)Install all accessories.
14.)Turn ON power to the system.
8-8-1-6 Printer Installation Procedure (For Systems with Existing Printer)
1.) Perform Steps 8 - 14 of the section Printer Installation Procedure (For Systems with No Existing
Printer) .
• Upper eTower Front Cover Installation Procedure
• Left Side eTower Cover Installation Procedure
• Right Side eTower Cover Installation Procedure
• Lower Front eTower Cover Installation Procedure
• RS Probe Cover Installation Procedure
• Accessories - Replacement Procedures
Perform the checks listed in Printer USB Cable Replacement Procedure on page 8-218
To Next Page
Loading...
