gefran SIEIDrive ADV100 - Page 41

ADV100 • Functions description and parameters list 41
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
10.11 968 Digsetspeedref rpm UINT16 16/32BIT 0 CALCI CALCI RW FVS
Setting of the threshold used as the speed reference: this parameter is used to set a xed threshold regardless of
the speed reference.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
10.12 970 Speedthreshold3 rpm INT32 0 0 CALCI ERW FVS
Setting of the speed 3 threshold. When this threshold + the tolerance band set in parameter 972Speedthrhyster-
esis are exceeded, parameter 976Speedthr3mon is enabled. The signal is disabled when the motor speed falls
below the threshold - the tolerance band. If the threshold value is lower than the value set in 972Speedthrhyster-
esis, the result produced is always 0. The value set in this parameter is active in both directions of rotation.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
10.13 972 Speedthrhysteresis rpm UINT16 0 0 CALCI RW FVS
Setting of the tolerance band around Speedthreshold3. The tolerance band is the same for both directions of rota-
tion of the motor.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
10.14 980 Currentthreshold perc UINT16 100 0 200 RW FVS
Setting of the current threshold. A value of 100% corresponds to the value of the drive heavy duty continuous cur-
rent, displayed in parameter 488Drivecontcurrent. When this threshold + the tolerance band set in parameter 982
urrentthrhyster are exceeded, parameter 986Currentthrmon is enabled. The signal is disabled when the motor
speed falls below the threshold - the tolerance band. If the threshold value is lower than the value set in 982Current
thrhyster, the result produced is always 0. The value set in this parameter is active in both directions of rotation.