Safety Rules
Follow these operating instructions for UAV safe use:
• UAV launch and maintenance can be held only by persons, who trained accord-
ing to the «Theoretical and practical training of Geoscan 201 unmanned aerial
system control».
• Follow dealer’s and/or manufacturer’s recommendations and instructions for use
of the equipment, as given in this manual and received during operation period.
• Before the ight it is necessary to inspect the ight area and make sure that the
planned ight path passes not less than 100 m above the terrain and high-rise
objects (mountains, towers, pipes, transmission towers, etc.).
• There should be no high objects in ±30° takeoff sector. Max safe height of an
object should be no more than 0.1L if L is the distance from takeoff point.
• Before straining the catapult rubber cords, make sure that the safety lock is
plugged in. Safety lock must stay plugged in until the launch moment.
• DO NOT launch the UAV, if any damage is detected.
• DO NOT stay in propeller rotation plane after battery connection.
• DO NOT exceed UAV’s altitude, mass and ight time operational limits.
• DO NOT launch or y UAV near high power radio transmitters.
• DO NOT allow unauthorized persons into the UAV launch area.
• DO NOT assemble or disassemble the UAV when the power is on.
• DO NOT short circuit the battery.
• AVOID ying above crowded places.
• Installation and removing of propeller’s blades is allowed only when UAV power
is off.
10
To Next Page
Loading...
