Pre-launch Check
Launch Start Preparing Wizard.
Start Preparing Wizard launch button
Follow the instructions of the Start preparing Wizard (most tests are runned automatically).
On Parameters stage set:
Parashute autodeatach radius (m) — radius around landing point, that trigged parashute autodetach af-
ter landing.
Example: If trees, transmission towers or any other barriers stays on landing route set value less than
150 m. It helps to off autodetach, if UAV will landed on a tree.
The value shuld be in range from 0 to 300 m, where 0 — disabled autodetach system.
Autonomous ight time (sec) — time after radio signal loss that UAV will y in automatic mode. If the
connection is not restored in this time, UAV will start retun to start point.
RTL Voltage (v) —battery voltage cut-off, that launch immediate landing. Cut-off safety range: from 13.6
to 16.6 v.
RTL minimum altitude (m) — altitude cut-off that launch immediate landing. It sets if terrain or other
barriers can block return route. Safety value range: from 100 to 4000 m.
Flight mission settings
Place UAV on the launcher’s carriage after successful pre-launch check.
85
To Next Page
Loading...