Battery Connecting
1. Check charge settings.
2. Connect balance cable to the battery.
3. Connect charge cable to the battery.
4. Long press Start/Enter button, until the charger will change status to Battery Check.
After successful cells check battery charger will start charging process automatically.
You can use car’s 12 V battery as charger power source. Make sure that you turn
car engine on to avoid full discharge of car’s battery.
Recommendations for Battery and Charger Using
• Store the battery in warm place without any condensation before ights in below 0 °C
temperature conditions. Remember that LiPo batteries can lose up to 30% of capacity
in cold temperature.
• Store the batteries in dry cool place without direct sun light before ights in temper-
atures more than +25 °C. Do not charge batteries directly before ight. Wait for a mo-
ment, when battery temperature is cool down. Charge the battery in dry cool place
without direct sun light.
• Charge the batteries directly after using to avoid full discharge.
• Do not overcharge or overdischarge the battery The voltage for each cell must be in
range of 3,3 to 4,2 V. Full voltage on power socket must in range of 16,5 - 21 V.
• Do not charge the battery in cold place, if you planning to move it to warm place. The
temperature risen can be reason to battery overcharge and damage or re.
• Do not store batteries fully discharged or fully charged.
For a long storage (more than 14 days) charge the batteries to 50% of full capacity and
correct charge level to 50% once in 5-6 months.
Store batteries in dry cool place with relative humidity no mor than 80% without direct
sun lights and any condensation.
• Make full charge-discharge cicle after long time storage.
• Optimum temperature for charge, storage and using is +15 °С.
• Service life: 1 year.
Battery Recycling
Do not utilize batteries with household trash. It may be dangerous for ecology.
Send them to recycling points.
70
To Next Page
Loading...
